WKUP_VBUS_EN=WKUP_VBUS_EN_0, WKUP_ID_EN=WKUP_ID_EN_0, WKUP_SW_EN=WKUP_SW_EN_0, OVER_CUR_POL=OVER_CUR_POL_0, WIR=WIR_0, WKUP_SW=WKUP_SW_0, WIE=WIE_0, PWR_POL=PWR_POL_0, WKUP_DPDM_EN=WKUP_DPDM_EN_0, OVER_CUR_DIS=OVER_CUR_DIS_0
USB OTG1 Control Register
| OVER_CUR_DIS | Disable OTG1 Overcurrent Detection 0 (OVER_CUR_DIS_0): Enables overcurrent detection 1 (OVER_CUR_DIS_1): Disables overcurrent detection |
| OVER_CUR_POL | OTG1 Polarity of Overcurrent The polarity of OTG1 port overcurrent event 0 (OVER_CUR_POL_0): High active (high on this signal represents an overcurrent condition) 1 (OVER_CUR_POL_1): Low active (low on this signal represents an overcurrent condition) |
| PWR_POL | OTG1 Power Polarity This bit should be set according to PMIC Power Pin polarity. 0 (PWR_POL_0): PMIC Power Pin is Low active. 1 (PWR_POL_1): PMIC Power Pin is High active. |
| WIE | OTG1 Wake-up Interrupt Enable This bit enables or disables the OTG1 wake-up interrupt 0 (WIE_0): Interrupt Disabled 1 (WIE_1): Interrupt Enabled |
| WKUP_SW_EN | OTG1 Software Wake-up Enable 0 (WKUP_SW_EN_0): Disable 1 (WKUP_SW_EN_1): Enable |
| WKUP_SW | OTG1 Software Wake-up 0 (WKUP_SW_0): Inactive 1 (WKUP_SW_1): Force wake-up |
| WKUP_ID_EN | OTG1 Wake-up on ID change enable 0 (WKUP_ID_EN_0): Disable 1 (WKUP_ID_EN_1): Enable |
| WKUP_VBUS_EN | OTG1 wake-up on VBUS change enable 0 (WKUP_VBUS_EN_0): Disable 1 (WKUP_VBUS_EN_1): Enable |
| WKUP_DPDM_EN | Wake-up on DPDM change enable 0 (WKUP_DPDM_EN_0): DPDM changes wake-up to be disabled only when VBUS is 0. 1 (WKUP_DPDM_EN_1): (Default) DPDM changes wake-up to be enabled, it is for device only. |
| WIR | OTG1 Wake-up Interrupt Request This bit indicates that a wake-up interrupt request is received on the OTG1 port 0 (WIR_0): No wake-up interrupt request received 1 (WIR_1): Wake-up Interrupt Request received |